Specification
| Type | Sand Filter |
| Process | Filtration |
| Material | FRP |
| Pressure Rating | 5 kg/cm2 |
| Temperature | Below 60 degree celcius |
| Operating Mode | Manual |
| Working Turbidity | 50 ppm |
| Water Source | Boring water, Tap water, Municipal Water |
| Warranty | 12 Months |
| Installation
& After Sales
Services | Yes |
Applications
- Home and apartments
- Drinking Water
- Process water for manufacturing plants
- Boiler feed water and cooling water make-up
- Hospital, hotel, institute, laundries and more
Item in the box
| Component | Qty |
|---|
| FRP Vessel* | 1 No. |
| Multiport Valve (Manual)* | 1 No. |
| Sand* | Quantity based on design |
| Supporting Media* | Quantity based on design |
| Skid (Optional)* | 1 No. |
| Pipe & Pipe Fittings* | Lump sump |
* Order Your Filter acts as your virtual assistant, and based on the input data provided, it designs and does the costing for you! All the dimensions, quantity, and brand of components will depend on the design and your choice of components.
The images shown are for illustration purposes only and may not be an exact representation of the product.
- In order to reduce the Sand Filters sizing and thus costing, it is highly recommended to install them before and near to your storage tank.
- The Sand Filters should be kept away from the heater or any heat outlet. It is also recommended that the Sand Filters should be installed under shed or provided a shed to protect it from direct sunlight & rain.
- The location should have access to a main water supply line to connect the
- The backwash will be required after predefined time period based on the design of Sand Filters. The water flow will be required at the time of backwash.
- The Sand Filters should be installed lower than overhead tank.
- The Sand Filters should be located close to the drain. The drain should not be beyond 10 feet from the installation location as well as should not be more than 5 feet above floor level.
- The installation location should be easily accessible, where all the equipment and materials can be carried easily.
- The installation location should have enough space for the Sand Filters unit and allows easy access for future maintenance .
-
- Bypass line along with ball valves should be provided. Bypass line will greatly help in maintaining the Sand Filters.
- A non-return valve of good quality should be provided, so that water will not return during backwash of the system.
-
The typical time required for Sand Filter backwash would be in between 5 to 20 minutes and consists of backwash and rinse.
Manual Sand Filters need to be manually backwashed on regular frequency as per the design of system.
